Dell PowerVault DL2000 Hardware Owner's Manual page 52

Table 2-5. Integrated Devices Screen Options (continued)
Option
Embedded Gb
NIC1
(Enabled with PXE
default)
MAC Address
TOE Capability
Embedded Gb
NIC2
(Enabled with PXE
default)
MAC Address
TOE Capability
Diskette Controller
(Auto default)
OS Watchdog
Timer (Disabled
default)
I/OAT DMA
Engine (Disable
default)
System Interrupts
Assignment
(Standard default)
52
Using the System Setup Program
Description
Enables or disables the system's integrated NIC. Options are
Enabled without PXE, Enabled with PXE, and Disabled. PXE
support allows the system to boot from the network. Changes
take effect after the system reboots.
Displays the MAC address for the integrated 10/100/1000 NIC.
This field does not have user-selectable settings.
Displays the TCP/IP offload engine (TOE) feature status of the
onboard NIC.
Enables or disables the system's integrated NIC. Options are
Enabled without PXE, Enabled with PXE, and Disabled. PXE
support allows the system to boot from the network. Changes
take effect after the system reboots.
Displays the MAC address for the integrated 10/100/1000 NIC.
This field does not have user-selectable settings.
Displays the TCP/IP offload engine (TOE) feature status of the
onboard NIC.
Enables or disables the system's diskette drive controller. When
Auto is selected, the system turns off the controller when
necessary to accommodate a controller card installed in an
expansion slot. You can also configure the drive as Read-Only,
or Off. When using the Read-Only setting, the drive cannot be
used to write to a disk.
NOTE:
This feature is usable only with operating systems that
support WDAT implementations of the Advanced Configuration
and Power Interface (ACPI) 3.0b specification.
Sets a timer that monitors the operating system for activity and
aids in recovery if the system stops responding. When this field
is set to Enabled, the operating system is allowed to initialize
the timer. When set to Disabled, the timer is not initialized.
Enables or disables the I/O Acceleration Technology (I/OAT)
option. This feature should be enabled only if the hardware and
software support I/OAT.
Controls the interrupt assignment of PCI devices in the system.
Distributed swizzles the interrupt routing to minimize IRQ
sharing.