ZyXEL Communications NWA3000-N User Manual page 99

Each field is described in the following table.
Table 34 Configuration > LAN Setting
LABEL
IP Address
Assignment
Get
Automatically
Use Fixed IP
Address
IP Address
Subnet Mask
Gateway
DNS Server
Settings
Add
Edit
Remove
Move
#
Type
DNS Server
VLAN Settings
Management
VLAN ID
As Native VLAN
Apply
Reset
NWA3000-N Series User's Guide
DESCRIPTION
This option appears when the MGNT Mode is set to Stand Alone AP. Select
this to make the interface a DHCP client and automatically get the IP address,
subnet mask, and gateway address from a DHCP server.
Select this if you want to specify the IP address, subnet mask, and gateway
manually. You can only configure a fixed IP address when the MGNT Mode is
set to Stand Alone AP.
Enter the IP address for this interface.
Enter the subnet mask of this interface in dot decimal notation. The subnet
mask indicates what part of the IP address is the same for all computers in the
network.
Enter the IP address of the gateway. The device sends packets to the gateway
when it does not know how to route the packet to its destination. The gateway
should be on the same network as the interface.
Use this section to specify the IP addresses for the device to use. Use one of
the following ways to specify these IP addresses.
User-Defined - enter a static IP address.
From ISP - select the DNS server that another interface received from its
DHCP server.
Click this to create a new entry. Select an entry and click Add to create a new
entry after the selected entry.
Double-click an entry or select it and click Edit to be able to modify the entry's
settings.
To remove an entry, select it and click Remove. The device confirms you want
to remove it before doing so. Note that subsequent entries move up by one
when you take this action.
To change an entry's position in the numbered list, select the entry and click
Move to display a field to type a number for where you want to put it and
press [ENTER] to move the rule to the number that you typed.
This is the index number of the DNS server address entry. The ordering of
your entries is important as the device uses them in sequence.
A hyphen (-) displays for the default DNS server address entry. The device
uses this default entry if it cannot get a reply for any of the other servers.
This displays whether the DNS server IP address is assigned by a DHCP server
dynamically (From DHCP), is configured manually (User-Defined), or is the
default entry the device uses if it cannot get a reply for any of the other
servers.
This is the IP address of a DNS server. This field displays N/A if you have the
device get a DNS server IP address from the ISP dynamically but the LAN
interface is using a static IP address.
Enter a VLAN ID for the device.
Select this option to treat this VLAN ID as a VLAN created on the device and
not one assigned to it from outside the network.
Click Apply to save your changes back to the device.
Click Reset to return the screen to its last-saved settings.
Chapter 8 LAN Setting
99