ZyXEL Communications NWA3000-N User Manual page 65

Click Configuration > Wireless > DCS.
1
Select Enable Dynamic Channel Selection to turn on this feature.
2
Set the DCS Time Interval. This is how often the device surveys the other APs within its broadcast
3
radius. If you place your APs in an area with a large number of competing APs, set this number
lower to ensure that your device can adjust quickly changing conditions.
Select DCS Sensitivity Level. This is how sensitive the APs on your network are to other channels.
4
Generally, as long as the area in which your AP is located has minimal interference from other
devices you can set the DCS Sensitivity Level to Low. This means that the AP has a very broad
tolerance.
Select Enable DCS Client Aware. Select this so that the APs on your network do not change
5
channels as long as any wireless clients are connected to them. When they must change channels,
they will wait until all stations disconnect first.
Set the 2.4-GHz Channel Selection Method to auto.
6
Select a 2.4 GHz Channel Deployment scheme. Choose Three-Channel Deployment to have
7
the device rotate through 3 channels. Choose Four-Channel Deployment to have the device
rotate through 4 channels, if allowed.
Click Apply to save your changes.
8
See also: Chapter 9 on page
NWA3000-N Series User's Guide
101.
Chapter 4 Tutorials
65