Telnet; Ftp - ZyXEL Communications NWA3000-N User Manual

15.7 Telnet

You can use Telnet to access the device's command line interface. Click Configuration > System
> TELNET to configure your device for remote Telnet access. Use this screen to enable or disable
Telnet and set the server port number.
Figure 95 Configuration > System > TELNET
The following table describes the labels in this screen.
Table 75 Configuration > System > TELNET
LABEL
Enable
Server Port
Apply
Reset

15.8 FTP

You can upload and download the device's firmware and configuration files using FTP. To use this
feature, your computer must have an FTP client. See
about firmware and configuration files.
NWA3000-N Series User's Guide
DESCRIPTION
Select the check box to allow or disallow the computer with the IP address that
matches the IP address(es) in the Service Control table to access the device CLI
using this service.
You may change the server port number for a service if needed, however you
must use the same port number in order to use that service for remote
management.
Click Apply to save your changes back to the device.
Click Reset to return the screen to its last-saved settings.
Chapter 17 on page 219
Chapter 15 System
for more information
195