ZyXEL Communications NWA3000-N User Manual page 271

Table 110 CAPWAP Client Logs
LOG MESSAGE
Updated configuration
by a WLAN Controller
Success. %s
Updated configuration
by a WLAN Controller
Fail. %s
ReBoot by a WLAN
Controller. WLAN
Controller:%s
Switch Managed AP to
Standalone AP. WLAN
Controller:%s
Firmware upgraded by
WLAN Controller. WLAN
Controller:%s
Apply configuration by
a WLAN Controller
Success. %s
Managed AP
Configuration Flush.
%s
AC IP Change. New
Discovery Type:%s,
WLAN Controller IP: %s
Managed AP Receiving
Complete ZySH
Configuration from AC
Managed AP Receiving
Updating ZySH Configuration
from AC
STA Association.
MAC
Addr:%02x:%02x:%02x:%0
2x:%02x:%02x,AP=%s
STA Disassociation.
MAC
Addr:%02x:%02x:%02x:%0
2x:%02x:%02x,AP=%s
STA Roaming.
MAC
Addr:%02x:%02x:%02x:%0
2x:%02x:%02x, From=%s,
To=%s
STA List Full. STA List of
Managed AP [%s] is Full
NWA3000-N Series User's Guide
DESCRIPTION
The configuration was upgraded successfully by the WLAN Controller.
1st %s: Partial Updating."
Configuration upgrade by the WLAN Controller failed.
1st %s: Wrong Configuration."
The managed AP was rebooteed WLAN Controller.
1st %s: WLAN Controller IP Address."
The WLAN controller set the managed AP to Standalone Mode.
1st %s: WLAN Controller IP Address."
The CAPWAP client's firmware was upgraded by the WLAN controller.
1st %s: WLAN Controller IP Address."
The WLAN controller successfully applied configuration.
1st %s: Complete Updating"
The managed AP reset ZySH for flushing its running-config &
reapplied the startup-config.
1st %s: Reset ZySH Daemon
Changed the managed AP's AC IP.
1st %s: Discovery type {By DHCP | Broadcast}
2nd %s: WLAN Controller IP Address"
The managed AP is receiving total configuration from the WLAN
Controller during CAPWAP protocol handshaking. (Configuration
Change State)
The AP is receiving configuration settings from the device because
the device changed configuration. (RUN State)
Indicates the specified station associated with the specified AP.
1st %02x~6th%02x: Station MAC Address.
7th %s: AP's description.
Indicates the specified station de-associated from the specified AP.
1st %02x~6th%02x: Station MAC Address.
7th %s: AP's description.
The specified station roamed from the first specified AP to the other.
1st %02x~6th%02x: Station MAC Address.
7th %s: Source AP's description.
8th %s: Destination AP's description.
The number of stations connecting to the specified AP has reached its
upper limit.
1st %s: WTP's description.
Appendix A Log Descriptions
271