ZyXEL Communications NWA3000-N User Manual page 199

The following table describes the labels in this screen.
Table 78 Configuration > System > SNMP
LABEL
Enable
Server Port
Trap
Community
Destination
SNMPv2c
Get Community
Set Community
SNMPv3
Add
Edit
Remove
#
User Name
Authentication
Privacy
Privilege
Apply
Reset
NWA3000-N Series User's Guide
DESCRIPTION
Select the check box to allow or disallow users to access the device using SNMP.
You may change the server port number for a service if needed, however you
must use the same port number in order to use that service for remote
management.
Type the trap community, which is the password sent with each trap to the SNMP
manager. The default is public and allows all requests.
Type the IP address of the station to send your SNMP traps to.
Select this to allow SNMP managers using SNMPv2c to access the device.
Enter the Get Community, which is the password for the incoming Get and
GetNext requests from the management station. The default is public and allows
all requests.
Enter the Set community, which is the password for incoming Set requests from
the management station. The default is private and allows all requests.
Select this to allow SNMP managers using SNMPv3 to access the device.
Click this to create a new entry. Select an entry and click Add to create a new
entry after the selected entry.
Double-click an entry or select it and click Edit to be able to modify the entry's
settings.
To remove an entry, select it and click Remove. The device confirms you want to
remove it before doing so. Note that subsequent entries move up by one when
you take this action.
This the index number of an SNMPv3 user profile.
This is the name of the user for which this SNMPv3 user profile is configured.
This field displays the type of authentication the SNMPv3 user must use to
connect to the device using this SNMPv3 user profile.
This field displays the type of encryption the SNMPv3 user must use to connect to
the device using this SNMPv3 user profile.
This field displays whether the SNMPv3 user can have read-only or read and write
access to the device using this SNMPv3 user profile.
Click Apply to save your changes back to the device.
Click Reset to return the screen to its last-saved settings.
Chapter 15 System
199