ZyXEL Communications NWA3000-N User Manual page 194

Chapter 15 System
15.6.5.2 Example 2: Linux
This section describes how to access the device using the OpenSSH client program that comes with
most Linux distributions.
Test whether the SSH service is available on the device.
1
Enter "telnet 192.168.1.2 22" at a terminal prompt and press [ENTER]. The computer
attempts to connect to port 22 on the device (using the default IP address of 192.168.1.2).
A message displays indicating the SSH protocol version supported by the device.
Figure 93 SSH Example 2: Test
$ telnet 192.168.1.2 22
Trying 192.168.1.2...
Connected to 192.168.1.2.
Escape character is '^]'.
SSH-1.5-1.0.0
Enter "ssh –1 192.168.1.2". This command forces your computer to connect to the device using
2
SSH version 1. If this is the first time you are connecting to the device using SSH, a message
displays prompting you to save the host information of the device. Type "yes" and press [ENTER].
Then enter the password to log in to the device.
Figure 94 SSH Example 2: Log in
$ ssh –1 192.168.1.2
The authenticity of host '192.168.1.2 (192.168.1.2)' can't be established.
RSA1 key fingerprint is 21:6c:07:25:7e:f4:75:80:ec:af:bd:d4:3d:80:53:d1.
Are you sure you want to continue connecting (yes/no)? yes
Warning: Permanently added '192.168.1.2' (RSA1) to the list of known hosts.
Administrator@192.168.1.2's password:
The CLI screen displays next.
3
194
NWA3000-N Series User's Guide