ZyXEL Communications NWA3000-N User Manual page 103

settings if it is in standalone mode or the general wireless settings of all of the device's managed
APs if the device is in controller mode.
Figure 39 Configuration > Wireless > AP Management (Controller Mode)
The following fields display if the Ndevice is in controller mode.
Table 37 Configuration > Wireless > AP Management (Controller Mode)
LABEL
Edit
Remove
Reboot
#
IP Address
MAC
Model
R1 Mode / Profile
R2 Mode / Profile
Mgnt. VLAN ID
Description
Figure 40 Configuration > Wireless > AP Management (Standalone Mode)
NWA3000-N Series User's Guide
DESCRIPTION
Select an AP and click this button to edit its properties.
Select an AP and click this button to remove it from the list.
Note: If in the Configuration > Wireless > Controller screen you set the
Registration Type to Always Accept, then as soon as you remove an
AP from this list it reconnects.
Select an AP and click this button to force it to restart.
This field is a sequential value, and it is not associated with any interface.
This field displays the IP address of the AP.
This field displays the MAC address of the AP.
This field displays the AP's hardware model information. It displays "N/A" (not
applicable) only when the AP disconnects from the device and the information
is unavailable as a result.
This field displays the AP or MON profile for Radio 1.
If the device has a second radio this field displays the AP or MON profile for
Radio 2.
This field displays the ID of the AP's management VLAN.
This field displays the AP's description, which you can configure by selecting
the AP and clicking the Edit button.
Chapter 9 Wireless
103