Daikin ETSX16E Installer's Reference Manual page 225

Overview field settings
Export MMI settings
EPRA14~18D + ETSH/X(B)16P30+50E
Daikin Altherma 3 H HT ECH₂O
4P679467-1D – 2023.11
▪ Outdoor ambient temperature is low enough
▪ Temperature at the outdoor unit heat exchanger coil is low enough
# Code
[9.H] N/A
NOTICE
Forced defrost start-up. You can only start forced defrost when the heating
operation has been running for a while.
Almost all settings can be done using the menu structure. If for any reason it is
required to change a setting using the overview settings, then the overview
settings can be accessed in the field settings overview [9.I]. See
4
overview setting" [ 144].
About exporting the configuration settings
Export the configuration settings of the unit to a USB memory stick, via the MMI
(the user interface of the indoor unit). When troubleshooting, these settings can
be provided to our Service department.
# Code
[9.N] N/A
To export MMI settings
1 Open the user interface panel and insert a USB memory stick.
2 On the user interface, go to [9.N] Export MMI settings.
3 Select OK.
4 Remove the USB memory stick and close the user interface
panel.
Do you want to start a defrost operation?
▪ Back
▪
OK
Your MMI settings will be exported
to the connected storage device:
▪ Back
▪ OK
1
2
10 Configuration
|
Description
"To modify an
Description
Installer reference guide
—
—
225