Clean The Mixing And Feeding Robot - LELY Vector Operator's Manual

6.2.8

Clean the Mixing and Feeding Robot

Preparation
1. Manually drive (see Drive the Mixing and Feeding Robot Manually on page 5-34) the Mixing and
Feeding Robot to a clean and level place.
Empty the mixing bin
1. Connect the smartphone (see Connect the Smartphone to Device Software on page 5-15) to the Mixing
and Feeding Robot.
2. Open the feed door on the page Test > Testing motors > Feed door.
3. Push the button
4. Push until the feed door is closed.
Clean
Sharp rotating knives.
Risk of severe injury or death.
Remove the key before you do work in the mixing bin.
Sharp knives.
Risk of injury.
Do not go inside the mixing bin during this procedure.
Do NOT use a high pressure cleaner to clean the outside of the Mixing and Feeding
Robot, this can cause serious damage to the electrical circuitry.
1. Switch off the Mixing and Feeding Robot with the key and remove the key (see Switch off the Mixing
and Feeding Robot with the Key (MFR 2) on page 5-10).
2. Use a pitch fork to remove all feed, do not climb into the mixing bin.
3. Clean the outside of the Mixing and Feeding Robot with a wet brush.
4. Clean the inside of the mixing bin with a wet brush or a high pressure cleaner.
6-16
.
in n o vato rs in ag ric u ltu re
Maintenance Procedures