Setting Of Proxy (Optional); Formatting A P2 Card - Panasonic AG-HPX300 Operating Instructions Manual

By attaching the video encoder card (AJ-YAX800G,
optional) either to the optional slot or Slot 5, it is possible to
specify the proxy recording setting.
The video encoder card is not recognized when inserted if
the power for the unit is turned ON. Insert the video encoder
card after turning off the power for the unit.
Select OPERATION > DEVICE SETUP > PROXY from
the thumbnail menu to specify the setting.
For the method of installation and the settings of the video
encoder card, refer to the operation manual of the video
encoder card.
Note
To use the proxy function in 24PN (Native) mode, the FPGA
version of the video encoder card firmware must be updated
to [B102] or higher. For the method to confirm the FPGA ver-
sion of the video encoder card firmware, refer to [Video
Encoder Card Status Display (optional)] (page 132). For
instructions on updating, refer to the P2 support page on the
following website.
https://eww.pavc.panasonic.co.jp/pro-av/
1
Press the THUMBNAIL button.
The thumbnail screen appears on the LCD monitor.
2
Press the THUMBNAIL MENU button and select
OPERATION > FORMAT from thethumbnail menu.
The following screen appears. Select the slot number
for the P2 card you want to format.
Select EXIT if formatting is not required.
126 Manipulating Clips with Thumbnails : Setting of Proxy (optional)

Setting of Proxy (optional)

Formatting a P2 Card

3
The following screen appears. Use the cursor buttons
and the SET button to select YES.
4
The selected P2 card is formatted.