Setting Of Proxy (Optional) - Panasonic AJ-SPC700 P Operating Instructions Manual

Chapter 6 Manuipulating Clips with Thumbnails
Selecting the USER CLIP NAME recording method
Select META DATA USER CLIP NAME from the menu
bar to select the recording method. Two options are
available: TYPE1 and TYPE2.
TYPE1
If clip metadata has been
read in
If no clip metadata has been
read in or if the setting for
recording clip metadata has
been turned off
TYPE2
If clip metadata has been
read in
If no clip metadata has been
read in or if the setting for
recording clip metadata has
been turned off
* The COUNT value is indicated as a four-digit number.
The COUNT value is incremented each time a new clip is
captured if clip metadata has been read in and TYPE2 has
been selected as the recording method.
The COUNT value can be reset using the following
procedure.
Select PROPERTY DEVICE
menu bar, then select USER CLIP NAME to display the
menu shown below. Select "COUNT RESET" with the
cursor and press the SET button to reset the COUNT
value to 1.
USER CLIP NAME to be recorded
Uploaded data
Same as GLOBAL CLIP ID
(UMID data)
USER CLIP NAME to be recorded
Uploaded data
+ COUNT value*
Same as CLIP NAME
META DATA from the
(continued)
<Note>
When a P2 card with a memory capacity of 8 GB or more is
used in this unit and a one-time continuous recording
exceeds the prescribed duration (approx. 10 minutes for
DVCPRO50 or approx. 20 minutes for DVCPRO or DV) or
when a one-time recording extends over more than one P2
card, the recording concerned will automatically be
undertaken as a separate clip. At this time, each clip will be
provided with its own COUNT value.
Example of recording (DVCPRO50) a clip on one P2 card
REC start (recording start)
Recording duration = Approx. 15 min.
Clip 1
COUNT value
= 0001
10 min.
Example of recording a clip on two P2 cards:
REC start (recording start)
Clip 1
COUNT value
= 0003
1st card
If the clip thumbnails are displayed as shown in the example
above or their properties are indicated using a P2 device, the
thumbnail and COUNT value of clip 1 will be displayed.
Clear the uploaded metadata
Select META DATA INITIALIZE from the menu bar, and
press the SET button. Select "YES" when the confirmation
screen is displayed.

6-13 Setting of Proxy (optional)

By attaching the video encoder card (AJ-YAX800G, optional)
either to the optional slot or Slot 5, it is possible to specify
the proxy recording setting.
Select OPERATION DEVICE SETUP
the menu bar to specify the setting.
For more information on settings, see the video encoder
card instruction manual.
REC/PAUSE (recording pause)
Clip 2
COUNT value
= 0002
5 min.
REC/PAUSE (recording pause)
Clip 2
COUNT value
= 0004
2nd card
PROXY from
85
6