Setting Of Proxy (Optional); Formatting A P2 Card - Panasonic AJ-HPX2700G Operating Instructions Manual

By attaching the video encoder card (AJ-YAX800G, optional)
either to the optional slot or slot 5, it is possible to specify the
proxy recording setting.
The video encoder card is not recognized when inserted if
the power for the unit is turned on. Insert the video encoder
card after turning off the power for the unit.
Select OPERATION
thumbnail menu to specify the setting.
For the method of installation and the settings of the video
encoder card, refer to the operation manual of the video
encoder card.
Notes
To use the proxy function in 24PN (Native) mode, the
FPGA version of the video encoder card firmware must be
updated to [B102] or higher. For the method to confirm the
FPGA version of the video encoder card firmware, refer to
[Video Encoder Card Status Display (optional)]
(page 140). For instructions on updating, refer to the P2
support page on the following website.
https://eww.pavc.panasonic.co.jp/pro-av/
1
Press the THUMBNAIL button.
The thumbnail screen appears on the LCD monitor.
2
Press the THUMBNAIL MENU button and select
OPERATION FORMAT from the thumbnail menu.
The following screen appears. Select the slot number
for the P2 card you want to format, then press the SET
button.
Select EXIT if formatting is not required.
134
Manipulating Clips with Thumbnails: Setting of Proxy (optional)

Setting of Proxy (optional)

DEVICE SETUP PROXY from the

Formatting a P2 Card

When "PROXY CARD ERROR" is indicated in the
viewfinder, either check the video encoder card or set the
unit so that proxy recording is not performed.
3
The following screen appears. Use the cursor buttons
and the SET button to select YES.
4
The selected P2 card is formatted.