Panasonic AG-HPX300 Operating Instructions Manual page 125

To set whether or not the uploaded metadata is
recorded
Set ON/OFF in META DATA > RECORD from the
thumbnail menu. The factory setting is OFF.
Selecting the USER CLIP NAME recording
method
Select META DATA > USER CLIP NAME from the
thumbnail menu to select the recording method. Two
options are available: TYPE1 and TYPE2.
TYPE1 (Factory setting
If clip metadata has been read in Uploaded data
If no clip metadata has been read
in or if the setting for recording
clip metadata has been turned off
TYPE2
If clip metadata has been read in
If no clip metadata has been read
in or if the setting for recording
clip metadata has been turned off
* The COUNT value is indicated as a four-digit number.
The COUNT value is incremented each time a new clip
is captured if clip metadata has been read in and TYPE2
has been selected as the recording method.
The COUNT value can be reset using the following
procedure.
Select PROPERTY > DEVICE > META DATA from the
thumbnail menu, then select USER CLIP NAME to
display the menu shown below. Select "COUNT RESET"
with the cursor and press the SET button to reset the
COUNT value to 1.
USER CLIP NAME to be
recorded
Same as GLOBAL CLIP ID
(UMID data)
USER CLIP NAME to be
recorded
Uploaded data + COUNT
value*
Same as CLIP NAME
Manipulating Clips with Thumbnails : Setting of Clip Meta Data
Note
When a P2 card with a memory capacity of 8 GB or more
is used in camera-recorder and a one-time continuous
recording exceeds the prescribed duration (DVCPRO HD
and the AVC-Intra 100: about 5 minutes; DVCPRO50 and
the AVC-Intra 50: about 10 minutes) or when a one-time
recording extends over more than one P2 card, the
recording concerned will automatically be undertaken as a
separate clip. At this time, each clip will be provided with
its own COUNT value.
Example of recording (DVCPRO HD) a clip on one P2 card:
REC start (recording start)
Recording duration = Approx. 7 min.
Clip 1
COUNT value
= 0001
5 min.
Example of recording a clip on two P2 cards:
REC start (recording start)
Clip 1
COUNT value
= 0003
1st card
If the clip thumbnails are displayed as shown in the
example above or their properties are indicated using a P2
device, the thumbnail and COUNT value of clip 1 will be
displayed.
Clear the uploaded metadata
Select META DATA > INITIALIZE from the thumbnail
menu, and press the SET button. Select "YES" when the
confirmation screen is displayed.
Notes
The setting for the displayed language is available only
when the area is set to "NTSC (J)". For details, refer to
[Color TV Standard Settings (Settings for frame
frequency)] (page 13).
Japanese or Chinese characters indicated in English or
other characters that cannot be indicated in English will
not display properly; they will be indicated as ¢ .
The letters which can be input with AJ-HPX3000 are
only the alphanumeric. AJ-HPX3000 cannot input
Japanese and Chinese.
REC/PAUSE (recording pause)
Clip 2
COUNT value
= 0002
2 min.
REC/PAUSE (recording pause)
Clip 2
COUNT value
= 0004
2nd card
125