Settings Of Signals Output From Mon Out Connector - Panasonic AG-HPX300 Operating Instructions Manual

Settings of signals output from MON OUT connector

The MON OUT connector outputs down-converted analog
signals.
Set the video signals output from the MON OUT connector
by using the MONITOR OUT item on the menu (<OUTPUT
SEL> screen on the SYSTEM SETTING page).
Variable
Item
range
MONITOR OUT VBS Set video signals output from the
VF MON OUT connector.
VBS: Analog composite signals are
Y
VF:
Y:
Settings of signals output from the SDI OUT/IN (OP) connector
The SDI OUT/IN (OP) connector outputs the same signal as
the SDI signal output from the VIDEO OUT connector.
The output signals are switched depending on the settings of
the signals output from the VIDEO OUT connector (refer to
page 80).
However, when the VIDEO OUT switch is set to VBS, it
depends on the settings of the SYSTEM MODE of the menu.
Position of the
SYSTEM MODE
VIDEO OUT switch
HD SDI
1080-59.94i
SD SDI
1080-50i
VBS
HD SDI
480-59.94i
SD SDI
576-50i
VBS
Remarks
output.
Y signals to be output to the
viewfinder is output. The
status screen is also
superimposed.
Analog HD-Y signals are
output.
SDI OUT/IN (OP)
connector output
signal
HD SDI
SD SDI
HD SDI
SD SDI
SD SDI
SD SDI
Adjustments and Settings for Recording : Selection of video output signals
Set to superimpose characters to the VBS signals output
from the MON OUT connector in the MONITOR OUT
CHARA item of the menu (<OUTPUT SEL> screen on the
SYSTEM SETTING page).
Variable
Item
range
MONITOR OUT ON Superimpose characters on the VBS
output signals from the MON OUT
CHARA OFF
connector.
ON: To superimpose
OFF:Not to superimpose
Note
This does not link with the VIDEO
OUT CHARACTER switch.
Remarks
81