Configure Nmea 0183; Coordinate System Selection - Lowrance LCX-112C Operation Instructions Manual

Configure NMEA 0183

You can configure the unit to use specific NMEA 0183 sentences.
1. Press
MENU
2. Press ↓ to
C
3. A menu appears showing the prefixes of the available NMEA
sentences. A check mark next to a prefix means the prefix is in use. Use
↑ ↓, → ← to select a prefix, then press
again to check the box and turn on a prefix.).
ENT
4. When the desired prefixes are checked or unchecked, press
| |
EXIT EXIT EXIT

Coordinate System Selection

The Coordinate System Menu lets you select the coordinate system to use
when displaying and entering position coordinates.
To get to Coordinate System Selection:
1. Press
MENU
2. Press ↓ to
C
This unit can show a position in degrees (36.14952°); degrees, minutes and
thousandths of a minute (36° 28.700'); or degrees, minutes, seconds and
tenths of a second (36° 28' 40.9"). It can also show position in: UTM
(Universal Transverse Mercator) projection; MGRS (Standard); MGRS
(Standard + 10); Map Fix; Loran TD; British, Irish, Finnish, German, New
Zealand, Swedish, Swiss, Taiwan, Greek and Military grids.
UTM's are marked on USGS topographic charts. This system divides the
Earth into 60 zones, each 6 degrees wide in longitude.
British, Irish, Finnish, German, New Zealand, Swedish, Swiss, Taiwan,
and Greek grid systems are each the national coordinate system used only
in their respective countries. In order to use these grid systems, you must
be in the respective country. This unit will pick the matching datum for
you when you select the grid. See the entry on Map Datum Selection for
more information.
| |↓ to
MENU S
P
OMMUNICATIONS
| to return to the previous page.
EXIT
Menus for changing coordinate system.
| |↓ to
MENU GPS S
S
OORDINATE YSTEM
|
S ENT
YSTEM ETUP
| |↓ to
ENT
ORT
ENT
| .
ENT
ETUP
| .
ENT
144
.
C NMEA
ONFIGURE
to turn off the prefix (Press
| .
ENT