Ep-15 Fluid Level Calibration - Lowrance LCX-112C Operation Instructions Manual

EP-15 Fluid Level Calibration

The default calibration for the EP-15 Fluid Level is just as accurate as standard
fluid level gauges. If, however, the tank has an irregular shape or greater
accuracy is needed, calibration is recommended. There are three calibration
options: 2-Point, 3-Point and 5-Point.
2-Point Calibration
A 2-point calibration is best suited for rectangular or square-shaped tanks,
where the capacity of the top half of the tank matches the capacity in the
lower half of the tank. In a two-point calibration, you will set two points,
one each for empty and full levels. You can begin calibration at either of
the two points, but we recommend starting with an empty tank. You will
fill the tank to complete calibration.
1. Press
MENU| MENU
2. Highlight
B
US
menu. A list of network devices will be at the top of the page.
3. Select the EP-15 Fluid Level and press
4. Press ↓ to select
will appear. Instructions on Calibration will be listed at the top of the menu.
5. Highlight
N
6.
Select F L
LUID
7. Make sure the fuel tank is empty, highlight
The following message will appear: Empty Level Calibration Completed.
Press ENT.
Fill up your tank, highlight
8.
Select
9. F L
ULL
The following message will appear
10.
Press , then press
ENT
Calibrate is highlighted on the device configuration menu (left).
Calibration menu (right) with calibration instructions listed at the top.
, use ↓ ↑ to select
and press
S
ETUP
C
ALIBRATE
, press
P ENT
UM TS
, press ENT, then select E
EVEL
and press
EVEL
repeatedly to get back to the main display.
EXIT
NMEA 2000
, which will open the Bus Configuration
ENT
ENT
and press
ENT
and select
MPTY
and press
F L
LUID EVEL
Highlight
ENT.
Full level Calibration Completed.
:
204
and press
.
. The Device Calibration menu
Press .
2. ENT
press
L and
EVEL
C
ALIBRATE
ENT.
and press
C
ALIBRATE
.
ENT
ENT.
and press
ENT
ENT.
.