To Adjust Sensitivity - Lowrance LCX-112C Operation Instructions Manual

You can change the sensitivity level whether you are in Auto
Sensitivity mode or Manual Sensitivity mode. The adjustment method
works the same in both modes, but gives you slightly different results.
Adjusting sensitivity in Auto Sensitivity Mode is similar to manually
adjusting a car's speed with the accelerator pedal while cruise control is
on. You can make the car to run faster, but when you let off the gas the
cruise control automatically keeps you from running slower than the
minimum speed setting. In this unit, auto mode will let you increase
sensitivity to 100 percent, but the unit will limit your minimum setting.
This prevents you from turning sensitivity down too low to allow
automatic bottom tracking. When you change the setting with auto
turned on, the unit will continue to track the bottom and make minor
adjustments to the sensitivity level, with a bias toward the setting you
selected.
Adjusting sensitivity in Manual Sensitivity Mode is similar to driving a
car without cruise control — you have complete control of the car's
speed. In this unit, manual mode allows you to set sensitivity at 100
percent (maximum) or zero percent (minimum). Depending on water
conditions, the bottom signal may completely disappear from the screen
when you reduce sensitivity to about 50 percent or less!
Try adjusting sensitivity in both auto and manual modes to see how
they work.

To adjust sensitivity:

1. Press |
MENU ENT.
2. The Sensitivity Control Bar appears. Press to decrease sensitivity;
↓
press to increase sensitivity. When it's set at the desired level, press
↑
. (When you reach the maximum or minimum limit, a tone sounds.)
EXIT
Sonar Menu with Sensitivity command selected (left). The Sensitivity
Control Bar (right).
57