Gps Simulator; Simulating Trail Or Route Navigation - Lowrance LCX-112C Operation Instructions Manual

GPS Simulator

The GPS simulator lets you use the unit as if you were navigating
outdoors. It's a great way to practice using your unit. You can set the
starting location from a stored waypoint, map place or POI location or by
entering latitude and longitude. You can steer your position and change
speed on the map by using the arrow keys (
or by setting the track and speed in the dialog boxes provided on the
simulator menu screen.
To get to the GPS Simulator:
1. Press
MENU
2. Press ↓ to
GPS S
GPS Setup Menu (left); GPS Simulator menu (right).
Choose the desired settings, then turn the simulator on by highlighting
the
GPS S
IMULATOR
to close this menu. A message and tone appear periodically, warning
you the simulator is on. To turn off the simulator, repeat the above
steps or turn off the unit.
While in simulator mode and using the
can press
EXIT
This will allow you to use the map cursor during a simulation. To turn
steering and speed boxes back on again, return to the GPS Simulator
menu. Select the

Simulating Trail or Route Navigation

In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps:
1. From the Map Page, go to the simulator menu. Pick a
at or near the beginning of your trail/route. Enter an approximate
(shown in compass degrees) that will point you toward the start of the
trail/route.
| |↓ to
MENU S
O
IMULATOR
box and pressing
O
N
to clear the steering and speed boxes from the screen.
S A
TEER WITH
|
S ENT
YSTEM ETUP
| . The GPS Simulator Menu appears.
ENT
N
ENT
S
TEER WITH
command, press
RROWS
148
S A
TEER WITH RROWS
.
key. Press
EXIT
A
RROWS
then
ENT,
S
command)
| |
EXIT EXIT
command, you
.
EXIT
P
TARTING OSITION
T
RACK