Installing A Power Supply In A J6300 Router - Juniper J2300 User Manual

Installing a Power Supply in a J6300 Router

To install a power supply in a J6300 Services Router (see Figure 109):
1.
2.
3.
4.
5.
NOTE: Each power supply must be connected to a dedicated AC power feed.
For information about connecting to AC power sources, see "Connecting Power
to the Services Router" on page 43.
6.
Figure 109: Installing an AC Power Supply
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to the ESD point on the chassis, or to an outside ESD point if
the router is disconnected from earth ground. For more information about
ESD, see "Preventing Electrostatic Discharge Damage" on page 567.
Using both hands, slide the power supply into the chassis until you feel
resistance.
Firmly push the power supply into the chassis until it comes to a stop. Make
sure that the power supply faceplate is flush with any adjacent power supply
faceplate.
Insert the appliance coupler end of a power cord into the appliance inlet on
the power supply faceplate.
Insert the power cord plug into an AC power source receptacle.
Verify that the power cord does not block access to router components or
drape where people might trip on it.
Replacing and Troubleshooting Hardware Components
Replacing Hardware Components
535