Installing The J2300 Services Router On A Wall - Juniper J2300 User Manual

J-series™ Services Router User Guide
To install the J2300 router on a desk:
1.
2.
3.
Figure 13: Attaching Rubber Feet to the J2300 Services Router

Installing the J2300 Services Router on a Wall

You can install the J2300 Services Router on a wall. The router is shipped
with mounting brackets and rubber feet in the accessory box. The rubber
feet help stabilize the router on the wall and enhance airflow.
To install the J2300 router on a wall:
1.
2.
3.
4.
5.
6.
38
Installing the J2300 Services Router
Turn the chassis upside-down on the desk or work surface where you intend to
operate the router.
Attach the provided rubber feet to the bottom of the chassis, as shown in
Figure 13.
Turn the chassis right-side up on the desk or work surface.
Rubber feet
Turn the chassis upside-down on a desk or work surface near where you
intend to operate the router.
Attach the provided rubber feet to the bottom of the chassis, as shown in
Figure 13.
Turn the chassis right-side up, and place it on a flat surface.
Position a mounting bracket on each side of the chassis as shown in Figure 14.
Use a number 2 Phillips screwdriver to install the screws that secure the
mounting brackets to the chassis.
If you are using wall anchors to support the chassis, install two pairs of anchors
on the wall, spaced 19 in. (48.3 cm) apart.