Deleting A Network Interface With A Configuration Editor - Juniper J2300 User Manual

Task
Create the basic configuration for the
new interface.
Add values for interface-specific options.
Most interface types have optional
parameters that are specific to the
interface type.
Add logical interfaces.

Deleting a Network Interface with a Configuration Editor

To delete an interface on a Services Router:
J-Web Configuration Editor
1.
Under Interface Name in the
table, click the name of the new
interface.
2. Enter values in the other fields on
this page if warranted.
All these entries are optional, but
you need to set values for Clocking
and Encapsulation in particular if
the default values are not suitable.
1. Under Nested configuration, click
Configure for the appropriate
interface type.
2.
In the interface-specific page that
appears, enter the values you need
to supply or change the default
values.
3.
When you are finished, click OK to
confirm your changes or Cancel
to cancel them and return to the
previous page.
1. In the main Interface page for this
interface, next to Unit, click Add
new entry.
2. In the Unit page for logical
interfaces that appears, enter a
number from 0 through 16384 in
the Interface unit number box.
3. Enter values in other fields as
required for your network.
4. To configure protocol family values
if needed, under Family, click
Configure next to the appropriate
protocol.
5. To access additional subordinate
hierarchies under Nested
configuration, click Configure next
to any parameter you want to
configure.
6. When you are finished, click OK to
confirm your changes or Cancel
to cancel them and return to the
previous page.
Configuring Network Interfaces with a Configuration Editor
Configuring Network Interfaces
CLI Configuration Editor
Enter values for physical interface
properties as needed. Examples include
changes to the default values for
physical encapsulation or MTU.
1. From the [edit interfaces
interface-name ] hierarchy level,
enter
edit interface -options
2. Enter the statement for each
interface-specific property for
which you need to change the
default value.
1. From the [edit interfaces
interface-name ] hierarchy level,
enter
set unit logical-unit-number
Replace logical-unit-number with a
value from 0 through 16384.
2.
Enter additional values for
properties you need to configure
on the logical interface, such as
logical encapsulation or protocol
family.
103