Verifying The Rip Configuration; Verifying The Rip-Enabled Interfaces - Juniper J2300 User Manual

Table 113: Configuring MD5 RIP Authentication
Task
Navigate to Rip level in the configuration
hierarchy.
Set the authentication type to MD5.
Set the MD5 authentication key
(password).
The key can be from 1 through
16 contiguous characters long and can
include any ASCII strings.

Verifying the RIP Configuration

To verify the RIP configuration, perform these tasks:

Verifying the RIP-Enabled Interfaces

Verify that all the RIP-enabled interfaces are available and active.
Purpose
From the CLI, enter the
Action
Sample Output
user@host> show rip neighbor
Source
Neighbor
--------
fe-0/0/0.0
fe-0/0/1.0
The output shows a list of the RIP neighbors that are configured on the Services
What It Means
Router. Verify the following information:
J-Web Configuration Editor
In the configuration editor hierarchy,
select Protocols>Rip.
From the Authentication type list, select
md5.
In the Authentication key box, type an
MD5 authentication key, and click OK.
Verifying the RIP-Enabled Interfaces on page 307
Verifying Reachability of All Hosts in the RIP Network on page 308
show rip neighbor
Destination
State Address
----- -------
Dn (null)
Up 192.168.220.5
Each configured interface is present. Interfaces are listed in alphabetical order.
Each configured interface is up. The state of the interface is listed in the
column. A state of
Destination State
traffic. A state of indicates that the link is not passing RIP traffic. In a
Dn
CLI Configuration Editor
From the top of the configuration
hierarchy, enter
edit protocols rip
Set the authentication type to md5:
set authentication-type md5
Set the MD5 authentication key:
set authentication-key password
command.
Send Receive In
Address
-----------
(null)
224.0.0.9
indicates that the link is passing RIP
Up
Verifying the RIP Configuration
Configuring a RIP Network
Mode Mode Met
---- ------- ---
mcast both 1
mcast both 1
307