Loading A Previous Configuration File; Setting A Rescue Configuration - Juniper J2300 User Manual

3.

Loading a Previous Configuration File

To download a configuration file from the Services Router to your local system:
To load (roll back) and commit a previous configuration file stored
on the Services Router:
1.
2.
NOTE: When you click Rollback, the Services Router loads and commits the
selected configuration. This behavior is different from entering the
configuration mode command from the CLI, where the configuration is loaded,
but not committed.

Setting a Rescue Configuration

If someone inadvertently commits a configuration that denies management access
to the Services Router, you can delete the invalid configuration and replace it with a
rescue configuration by pressing the
previously set the rescue configuration through the J-Web interface or the CLI. The
rescue configuration is a previously committed, valid configuration.
CAUTION: Pressing and holding the
deletes all configurations on the router, including the backup configurations and
rescue configuration, and loads and commits the factory configuration.
Select the options your Web browser provides that allow you to save the
configuration file to a target directory on your local system.
The file is saved as an ASCII file.
Select Configuration>History.
A list of the current and previous 49 configurations is displayed as
Configuration History in the main pane (see Figure 39). Table 47 summarizes
the Configuration History display.
In the Action column, click Rollback for the version of the configuration you
want to load.
The main pane displays the results of the rollback operation.
Managing Configuration Files with the J-Web Interface
Using J-series Configuration Tools
button on the router. You must have
CONFIG
button for longer than 15 seconds
CONFIG
rollback
145