Power Button And Power On Led; Config Button And Led - Juniper J2300 User Manual

J-series™ Services Router User Guide
To deactivate alarms, you must clear the condition that caused the alarm. For a list
of alarms that can occur on the router, see "Chassis Alarm Conditions" on page 536.

Power Button and POWER ON LED

The power button is located on the left side of the front panel (see
Figure 4). You can use the power button to power the Services Router
on and off. When you power on the router, the Routing Engine boots as
the power supply completes its startup sequence.
The
panel. Table 9 describes the
Table 9: POWER ON LED
Color
Green
After the router is powered on, status indicators—such as LEDs on the
front panel and
to indicate that the power supply is functioning normally. Ignore error
indicators that appear during the first 60 seconds.
If you need to power off the router after the Routing Engine finishes booting, use
the J-Web interface or the CLI to halt the Services Router first. For instructions, see
"Rebooting or Halting a Services Router with the J-Web Interface" on page 512.

CONFIG Button and LED

You can use the
you have determined is a stable, known configuration. The
recessed to prevent it from being pressed accidentally.
Table 10 describes the configuration LED.
12
J2300 Services Router Hardware Features
LED is located to the left of the power button on the front
POWER ON
State
Off
On steadily
Blinking
command output—can take up to 60 seconds
show chassis
button to return the router to a configuration that
CONFIG
When you press and release the
is loaded and committed.
When you press and hold the
configurations on the router (including the rescue configuration and backup
configurations) are deleted, and the factory configuration is loaded and
committed.
LED.
POWER ON
Description
Router is unplugged, or is powered off
and in standby mode.
Router is powered on and is either
booting or functioning normally.
Power button has been pressed and
quickly released, and the router is
gracefully shutting down.
button, the rescue configuration
CONFIG
button for more than 15 seconds, all
CONFIG
button is
CONFIG