Committing A Clickable Configuration; Viewing The Configuration Text - Juniper J2300 User Manual

J-series™ Services Router User Guide
The updated candidate configuration does not take effect on the
Services Router until you commit it.

Committing a Clickable Configuration

When you finish making changes to a candidate configuration with the J-Web
configuration editor's clickable interface, you must commit the changes to use them
in the current operational software running on the Services Router.
If another user is editing an exclusive candidate configuration with the CLI, you
cannot commit a configuration until the user has committed the configuration. To
display a list of users, see "Displaying Users Editing the Configuration" on page
142. For more information about editing an exclusive candidate configuration,
see "Entering and Exiting Configuration Mode" on page 146.
To commit a candidate configuration:
1.
2.
3.

Viewing the Configuration Text

To view the entire configuration in text format, select
Configuration>View and Edit>View Configuration Text. The
main pane displays the configuration in text format (see Figure 36).
Each level in the hierarchy is indented to indicate each statement's relative position
in the hierarchy. Each level is generally set off with braces, using an open brace (
at the beginning of each hierarchy level and a closing brace (
statement at a hierarchy level is empty, the braces are not displayed. Each leaf
statement ends with a semicolon (
This indented representation is used when the configuration is displayed or saved
as an ASCII file. However, when you load an ASCII configuration file, the format of
the file is not so strict. The braces and semicolons are required, but the indention
and use of new lines are not required in ASCII configuration files.
136
Using the J-Web Configuration Editor
In the J-Web configuration editor's clickable interface, click Commit.
The main pane displays a summary of your changes in statement form.
To confirm the commit operation, click OK.
To cancel a commit operation, click Cancel.
If multiple users are editing the configuration when you commit the candidate
configuration, all changes made by all users take effect.
To display all the edits applied to the running configuration, click Refresh.
), as does the last statement in the hierarchy.
;
)
{
) at the end. If the
}