Configuring A T3 Interface With Quick Configuration - Juniper J2300 User Manual

Field
Frame Checksum
Line Buildout

Configuring a T3 Interface with Quick Configuration

To configure properties on a T3 (DS3) interface:
1.
Function
Specifies the number of bits in the frame
checksum. A 32–bit checksum provides
more reliable packet verification,
but is not supported by some older
equipment.
Specifies the T1 cable length, in feet.
From the Quick Configuration page, as shown in Figure 25, select the interface
you want to configure.
The properties you can configure on a T3 interface are displayed, as shown in
Figure 29.
Configuring Network Interfaces with Quick Configuration
Configuring Network Interfaces
Your Action
Select 16 or 32. The default value is 16.
From the drop-down list, select one of
the following cable lengths:
0–132 (0 m–40 m) (the default)
133–265 (40 m–81 m)
266–398 (81 m–121 m)
399–531 (121 m–162 m)
532–655 (162m–200m)
95