Entering A Setup Password - HP xw3100 Service And Technical Reference Manual

Desktop Management
2. When the key icon appears on the monitor, type your current password, then press
Type carefully; for security reasons, the characters you type do not appear on the screen.
If you enter the password incorrectly, a broken key icon appears. Try again. After three
unsuccessful tries, you must turn off the workstation, then turn it on again before you can
continue.

Entering a Setup Password

If a setup password has been established on the workstation, you will be prompted to enter it each
time you run Computer Setup.
1. Turn on or restart the workstation. If you are in Windows, click Start > Shut Down >
Restart the Computer.
F10
2. Press the
If you do not press the
on again, and press the
3. When the key icon appears on the monitor, type the setup password, then press the
key.
Type carefully; for security reasons, the characters you type do not appear on the screen.
If you enter the password incorrectly, a broken key icon appears. Try again. After three
unsuccessful tries, you must turn off the workstation, then turn it on again before you can
continue.
Changing a Power-On or Setup Password
1. Turn on or restart the workstation. If you are in Windows, click Start > Shut Down >
Restart the Computer. To change the setup password, run Computer Setup.
2. When the key icon appears, type your current password, a slash (/) or alternate delimiter
character, your new password, another slash (/) or alternate delimiter character, and your new
password again as shown:
current password/new password/new password
Type carefully; for security reasons, the characters you type do not appear on the screen.
Enter
3. Press the
The new password takes effect the next time you turn on the workstation.
Refer to the "National Keyboard Delimiter Characters" section in this chapter for information
about the alternate delimiter characters.
The power-on password and setup password may also be changed using the Security options in
Computer Setup.
Deleting a Power-On or Setup Password
1. Turn on or restart the workstation. If you are in Windows, click Start > Shut Down >
Restart the Computer. To delete the setup password, run Computer Setup.
3–12
key as soon as the monitor light turns green.
F10
key at the appropriate time, you must turn the workstation off, then
F10
key again to access the utility.
key.
338611-001 Service and Technical Reference Guide, xw3100
Enter.
Enter