General Requirements - HP xw3100 Service And Technical Reference Manual

The voltage select switch feature on the workstation permits it to operate from any line voltage
between 100-120 or 220-240 volts AC.
The power cord set received with the workstation meets the requirements for use in the country
where you purchased the equipment.
Power cord sets for use in other countries must meet the requirements of the country where you
use the workstation. For more information on power cord set requirements, contact your
authorized HP dealer, reseller, or service provider.

General Requirements

The requirements listed below are applicable to all countries:
1. The length of the power cord set must be at least 6.00 feet (1.8 m) and a maximum of 9.75
feet (3.0 m).
2. All power cord sets must be approved by an acceptable accredited agency responsible for
evaluation in the country where the power cord set will be used.
3. The power cord set must have a minimum current capacity of 10A and a nominal voltage
rating of 125 or 250 volts AC, as required by each country's power system.
4. The appliance coupler must meet the mechanical configuration of an EN 60 320/IEC 320
Standard Sheet C13 connector, for mating with appliance inlet on the Switch Box.
Service and Technical Reference Guide, xw3100
Power Cord Set Requirements
B
B–1