Using Computer Setup (F10) Utilities - HP xw3100 Service And Technical Reference Manual

2.2.1 Using Computer Setup (F10) Utilities

Computer Setup can be accessed only by turning on the workstation or restarting the system. To
access the Computer Setup Utilities menu, complete the following steps:
1. Turn on or restart the workstation. If you are in Windows, click Start >Shut Down >Restart
the Computer.
F10
2. Press the
If you do not press the
on again, and press the
3. Select your language from the list and press the
4. A choice of four headings appears in the Computer Setup Utilities menu: File, Storage,
Security, and Advanced.
5. Use the arrow (left and right) keys to select the appropriate heading. Use the arrow (up and
down) keys to select the option you want, then press
Utilities menu, press
6. To apply and save changes, select File > Save Changes and Exit.
If you have made changes that you do not want applied, select Ignore Changes and
Exit.
To reset to factory settings, select Set Defaults and Exit. This option will restore the
original factory system defaults.
Ä
CAUTION: Do NOT turn the workstation power OFF while the ROM is saving your F10 Computer Setup
changes because the CMOS could become corrupted. It is safe to turn off all power to the workstation
after you exit the F10 Setup screen.
Service and Technical Reference Guide, xw3100
key as soon as the monitor light turns green.
F10
key at the appropriate time, you must turn the workstation off, then
F10
key again to access the utility.
Esc
.
338611-001
Computer Setup Utilities and Diagnostic Features
Enter
key.
Enter
. To return to the Computer Setup
2–3