Before You Partition Or Format The Current Bootable Disk; Cable Lock Provision; Fault Notification And Recovery; Drive Protection System - HP xw3100 Service And Technical Reference Manual

Upon entering Computer Setup, you must
Save the MBR of the current bootable disk; or
Disable the MBR Security feature.
You must know the setup password, if one exists.

3.5.2 Before You Partition or Format the Current Bootable Disk

Ensure that MBR Security is disabled before you change partitioning or formatting of the current
bootable disk. Some disk utilities, such as FDISK and FORMAT, attempt to update the MBR. If
MBR Security is enabled when you change partitioning or formatting of the disk, you may
receive error messages from the disk utility or a warning from MBR Security the next time the
workstation is turned on or restarted. To disable MBR Security, complete the following steps:
1. Turn on or restart the workstation. If you are in Windows, click Start > Shut Down >
Restart the Computer.
F10
2. Press the
screen, if necessary.
If you do not press the
on again, and press the
3. Select Security > Master Boot Record Security > Disabled.
4. Before exiting, click File > Save Changes and Exit.

3.5.3 Cable Lock Provision

The rear panel of the workstation accommodates a cable lock so that the workstation can be
physically secured to a work area.
For illustrated instructions, please see the "Removal and Replacement" Chapter.

3.6 Fault Notification and Recovery

Fault Notification and Recovery features combine innovative hardware and software technology
to prevent the loss of critical data and minimize unplanned downtime.
When a fault occurs, the workstation displays a Local Alert message containing a description of
the fault and any recommended actions. You can then view current system health by using the HP
Client Manager Software. If the workstation is connected to a network managed by HP Insight
Manager, HP Client Manager Software, or other system management applications, the
workstation also sends a fault notice to the network management application.

3.6.1 Drive Protection System

The Drive Protection System (DPS) is a diagnostic tool built into the hard drives installed in
select HP workstations. DPS is designed to help diagnose problems that might result in
unwarranted hard drive replacement.
When HP workstations are built, each installed hard drive is tested using DPS, and a permanent
record of key information is written onto the drive. Each time DPS is run, test results are written
to the hard drive. Your service provider can use this information to help diagnose conditions that
caused you to run the DPS software.
Service and Technical Reference Guide, xw3100
key as soon as the monitor light turns green. Press
F10
key at the appropriate time, you must turn the workstation off, then
F10
key again to access the utility.
338611-001
Desktop Management
Enter
to bypass the title
3–19