HP xw3100 Service And Technical Reference Manual page 100

POST Error Messages
POST Error Messages
Screen Message
163-Time & Date Not
Set
164-Memory Size Error
183-Invalid Processor
Jumper Setting
201-Memory Error
202-Memory Type
Mismatch
207-ECC Corrected
Single Bit Errors in
Memory Socket(s) y,y
212-Failed Processor
213-Incompatible
memory Module in
memory Socket(s)
X,X, X
C–2
Probable Cause
Invalid time or date in
configuration memory.
RTC (real-time clock)
battery may need to be
replaced.
CMOS jumper may not
be properly installed.
Memory configuration is
incorrect.
System board jumper
improperly set.
RAM failure.
Memory modules do not
match each other.
Single Bit ECC error.
Processor has failed to
initialize.
A memory module in
memory socket identified
in the error message is
missing critical SPD
information, or is
incompatible with the
chipset.
Recommended Action
Set the date and time under Control
Panel or in F10 Setup depending on
the operating system.
If the problem persists, replace the RTC
battery.
Run Computer Setup (F10 Setup) or
Windows utilities.
Make sure memory module(s) (if any) are
installed properly.
If third party memory has been added,
test using HP-only memory.
Verify proper memory module type.
Reset system board jumpers to match
processor and bus speeds (select
models).
Run Computer Setup (F10 Setup) or
Windows utilities.
Ensure memory and continuity modules
are installed correctly.
Verify proper memory module type.
Remove and replace memory module(s)
one at a time to isolate faulty module.
Replace the faulty memory module(s).
If error persists after replacing memory
modules, replace the system board.
Replace memory modules with matched
sets.
Verify proper memory module type.
Try another memory socket.
Replace memory module if problem
persists.
Reseat the processor in its socket.
If the processor does not respond,
replace it.
Verify proper memory module type.
Try another memory socket.
Replace memory with a module
conforming to the SPD standard.
Service and Technical Reference Guide, xw3100