Completing The Installation Of A Hard Disk Drive - HP Kayak XA05 Supplementary Manual

When a New SCSI Hard
Disk Drive Is Installed
When an IDE Drive
Is Installed
NOTE
1 How to Install Accessories In Your Desktop PC Workstation
Installing Mass Storage Devices

Completing the Installation of a Hard Disk Drive

1 Switch on the computer.
2 To enter the SCSI Configuration Utility press
Press F6 to start Configuration Utility...
during the PC Workstation's start-up routine.
3 Verify or modify the configuration of your new SCSI hard disk drive.
For more information on configuring a SCSI hard disk drive, refer
to the SCSI Administrator's Guide available on HP's Web site at
http://www.hp.com/go/kayaksupport
4 When configuration is complete, exit the SCSI Configuration Utility
and re-boot the computer to save any changes.
1 Switch on the computer.
2 To display the device in POST, press Esc while the PC Workstation
re-starts.
3 If an error message appears, follow the instructions provided by the
Error Message Utility.
4 To verify the configuration of your hard disk drive, press
Setup when prompted. Once in Setup, select the
the submenu. In the
IDE Devices
details for the device have been correctly detected by the Setup
program.
5 Press to save and exit Setup.
F3
Refer to the operating system documentation for information on
formatting a drive.
If an IDE drive is removed, switch on the computer. The system BIOS
will detect that the device is missing. Press
to remove the device. The system configuration will be updated
automatically.
16 English
when the message
F6
.
Advanced
item, check that the
Primary Master
to confirm that you want
F4
is displayed
to enter
F2
menu, then