HP Kayak XA05 Supplementary Manual page 52

2 How to Install Accessories In Your Minitower PC Workstation
Installing Mass Storage Devices
10 Connect the data and power cables to the rear of the device. (The
connectors are shaped to go in one way only.)
Data Cable
11 If you are installing a SCSI device, pass the SCSI cable through the
base of the SCSI holder. You will need to remove then replace the
SCSI holder to do this.
12 Slide the power supply back into position, and tighten the four self-
retaining screws (see page 32).
13 Replace the HP UltraFlow airflow guide and reconnect the fan to the
system board (see the illustration on page 31).
14 Install any other accessories before replacing the cover and
completing the installation.
15 Follow the instructions below to complete the installation.
42 English
Power Cable
Pass the SCSI cable
through the base of
the SCSI holder