Completing The Installation Of A Hard Disk Drive - HP Kayak XA-s02 User Manual

geron.bk : geron-2.fb4 Page 37 Friday, April 24, 1998 5:30 PM
When a SCSI Hard Disk
Drive Is Installed
When an IDE Drive
Is Installed
NOTE

Completing the Installation of a Hard Disk Drive

1 Switch on the computer.
2 To enter the SCSI Configuration Utility press
Press F6 to start Configuration Utility...
during the PC Workstation's start-up routine.
3 Verify or modify the configuration of your new SCSI hard disk drive.
For more information on configuring a SCSI hard disk drive, refer
to "Using the SCSI Configuration Utility (Selected Models Only)", on
page 94.
4 When configuration is complete, exit the SCSI Configuration Utility
and re-boot the computer to save any changes.
1 Switch on the computer.
2 To display the device in POST, press
re-starts.
3 If an error message appears, follow the instructions provided by the
Error Message Utility. When prompted, press
program.
4 Select the Advanced menu, and the IDE Devices submenu. In the
Primary Master item, check that the details for the device have been
correctly detected by the Setup program.
5 Press to save and exit Setup.
Refer to the operating system documentation for information on
formatting a drive.
If an IDE drive is removed, switch on the computer. The system BIOS
will detect that the device is missing. Press
to remove the device. The system configuration will be updated
automatically.
2 How to Install Accessories In Your HP Kayak PC Workstation
while the PC Workstation
to confirm that you want
Installing Mass Storage Devices
when the message
is displayed
to run the Setup
English 37