Completing The Installation Of A Hard Disk Drive - HP Kayak XW A2-U2-W2 User Manual

When a SCSI Hard Disk
Drive Is Installed
When an IDE Drive
Is Installed
10 Connect the data and power cables to the rear of the device. (The
connectors are shaped to go in one way only.)
Data Cable
11 Slide the power supply back into position, and tighten the four self-
retaining screws (see page 28).
12 Replace the HP UltraFlow airflow guide and reconnect the fan to the
system board (see the illustration on page 27).
13 Install any other accessories before replacing the cover and
completing the installation.
14 Follow the instructions below to complete the installation.

Completing the Installation of a Hard Disk Drive

1 Switch on the computer.
2 To ensure compatibility, use the FDISK utility to delete any
partitions on the new hard disk.
3 Re-boot the computer.
Refer to the operating system documentation for information on
formatting a drive.
1 Switch on the computer.
2 To display the device in POST, press
re-starts.
2 How to Install Accessories Inside Your PC Workstation
while the PC Workstation
Installing Mass Storage Devices
Power Cable
English 41