If You Are Unable To Change Any Values In Setup; If A Post Error Message Is Displayed - HP Kayak XA05 Supplementary Manual

Rebuild Your PC
Workstation's
Components
3 Troubleshooting Your HP Kayak PC Workstation
If Your PC Workstation Does Not Start Properly
6 Turn on the display and computer.
If your PC Workstation still does not start properly, remove all boards
and accessories, except the hard disk drive and video board. Start the
PC Workstation. If the PC Workstation now works, add the boards and
accessories one at a time to determine which one is causing the
problem.

If you are Unable to Change any Values in Setup

Ensure that you are using the correct password.

If a POST Error Message is Displayed

The Power-On-Self-Test (POST) can detect both an error and a change
to the configuration. In either case, an error code and short description
is displayed. Depending on the kind of error, you will have one or more
of these choices available on screen:
Press to ignore the message and continue.
•
F1
Press to run Setup and correct a system configuration error. HP
•
F2
recommends that you correct the error before proceeding, even if
the PC Workstation appears to start successfully.
Press to accept (validate) the change and update Setup's
•
F4
configuration information.
Press to see more details about the message. After viewing
•
Enter
these details, you will be returned to the original POST display
screen. If the message is actually a change to the configuration you
have made (for example, you have just removed some memory), you
can then press
F4
configuration information. Otherwise, press
message and continue, or press
configuration error. (The number of choices you will have available
are dependent on the kind of error.)
60 English
to accept the change and update Setup's
to run Setup and correct a system
F2
to ignore the
F1