Regulatory Compliance; Leds - Ruijie RG-AP810-I Hardware Installation And Reference Manual

Hardware Installation and Reference Guide
1.3.8

Regulatory Compliance

Table 1-11 Regulatory Compliance
Regulatory compliance
Regulatory compliance
1.4

LEDs

Note
The LED description applies to both Fit and Fat modes, unless otherwise specified.
Table 1-12 LED Status
Status
Off
Steady green
Steady red
Blinking red at an
interval of 1s
Blinking blue at an
interval of 0.2s
Steady blue
Blinking blue at an
interval of 1s
Blinking red at an
interval of 0.2s
RG-AP810-I
EN 55032, EN 55035, EN 61000-3-3, EN IEC 61000-3-2, EN 301 489-1, EN 301
489-3, EN 301 489-17, EN 300 328, EN 301 893, EN 300 440, FCC Part 15, EN
IEC 62311, IEC 62368-1, and EN 62368-1
Frequency
N/A
N/A
N/A
On for 3s
Off for 1s
On for 0.2s
Off for 0.2s
N/A
On for 1s
Off for 1s
On for 0.2s
Off for 0.2s
11
Description
The AP is not powered on.
The AP is powered on, but the LED is manually turned off.
The software system of the AP is being initialized.
The system is running properly, but the uplink service port
is in link-down state.
In Fit mode, the setup of a CAPWAP tunnel between the
AP and AC expires.
In Fit or MACC mode, the software system of the AP is
being updated.
The system is running properly, but no STA is online.
The system is running properly and one or more STAs are
online.
In Fit mode, the AP is being located.
Product Overview