Removing The Supervisor Engine Or A Module - Cisco 7603 - Modular Expansion Base Installation Manual

Chapter 3 Installing Modules
Figure 3-10

Removing the Supervisor Engine or a Module

This section describes how to remove a supervisor engine, OSM, Catalyst 6000 family module, or SIP
from the Cisco 7600 series router.
Before you remove a supervisor engine, you should first save the current configuration using the write
{host file | network | terminal} command. This step saves time when bringing the module back online.
You can recover the configuration by downloading it from the server to the nonvolatile memory of the
supervisor engine.
On any modules running Cisco IOS, save the current running configuration by entering the copy
Note
running-config startup-config command.
Tip When you install a new supervisor engine, check the factory default configuration; you might need to
reconfigure the system to your requirements. You can reconfigure the supervisor engine manually, or if
you previously uploaded the original configuration to a server, you can download it to the new supervisor
engine. Refer to the Cisco 7600 Series Internet Router Software Installation Guide for additional
information.
OL-5077-7
Installing a Module in the Cisco 7609 Router
FAN
STATUS
o

Removing the Supervisor Engine or a Module

o
INPUT FAN
OUTPUT
OK OK
FAIL
INPUT
FAN OUTPUT
OK
OK FAIL
Book Title
3-13