Chapter 1 Product Overview - Cisco 7603 - Modular Expansion Base Installation Manual

Cisco 7600 Series Routers
A supervisor engine with two modular Gigabit interface uplinks and an optional redundant
•
supervisor engine, in one of the following configurations:
–
–
–
–
–
–
–
Note
Note
Additional OSMs, recommended Catalyst 6000 family modules, and SIPs in any combination:
•
–
–
–
–
–
• Hot-swappable fan assembly, redundant AC-input or DC-input power supplies, and modules
• Redundant AC-input or DC-input power entry modules (PEMs) (Cisco 7603 and 7606 routers only)
• Backplane that provides 32 Gbps of bandwidth; scalable up to 256 Gbps
A Switch Fabric Module (WS-C6500-SFM or WS-X6500-SFM2):
•
–
–
–
–
Note For redundancy, you can install a redundant Switch Fabric Module. The module that is installed first
functions as the primary module. When you install two Switch Fabric Modules at the same time, the
module in slot 5 or slot 7 acts as the primary module, and the module in slot 6 or slot 8 acts as the backup.
If you reset the module in slot 5 or slot 7, the module in slot 6 or slot 8 becomes the primary module.
Note
Book Title
1-2
Supervisor Engine 2, Policy Feature Card 2 (PFC2), and Multilayer Switch Feature Card 2
(MSFC2)
Supervisor Engine 2, PFC2, MSFC2, and Switch Fabric Module (SFM) or SFM2
Supervisor Engine 720, PFC3A, and MSFC3
Supervisor Engine 720 with PFC3B, and MSFC3
Supervisor Engine 720 with PFC3BXL, and MSFC3
Supervisor Engine 32 with PFC3B, and MSFC2A
Route Switch Processor 720 (RSP720), a PFC3C or PFC3CXL, and MSFC4
The supervisor engine and redundant supervisor engine must be completely identical.
The uplink ports are fully functional on the redundant supervisor engine in standby mode.
Two additional modules for the Cisco 7603 router
Three additional modules for the Cisco 7604 router
Five additional modules for the Cisco 7606 router
Eight additional modules for the Cisco 7609 router
Twelve additional modules for the Cisco 7613 router
Only the Supervisor Engine 2 supports the Switch Fabric Module.
Supervisor Engine 720 does not support the Switch Fabric Modules.
Either the WS-C6500-SFM or WS-X6500-SFM2 Switch Fabric Module can be installed in slot
5 of of the Cisco 7606 or Cisco 7609 router. A redundant Switch Fabric Module can be installed
in slot 6.
Only the WS-X6500-SFM2 Switch Fabric Module can be installed in slot 7 of the Cisco 7613
router. A redundant WS-X6500-SFM2 Switch Fabric Module can be installed in slot 8.
The Switch Fabric Module is not supported on the Cisco 7603 router or the Cisco 7604 router.
Chapter 1 Product Overview
OL-5077-7