Cisco 7603 - Modular Expansion Base Installation Manual page 108

Troubleshooting Router Booting Issues
Table 4-2
Possible Problem
1. TFTP = Trivial File Transfer Protocol
Cisco 7600 Series Routers Module Guide
4-8
Booting: Vector Error Occurs When Booting from Flash Memory (continued)
Solution
The router prompts you to enter the IP address of the TFTP server and the name
of the image file that you are copying to the server. Here is a sample output for
this command using the IP address 131.108.10.6 and filename
c7600rsp72043-adventerprisek9-mz.122-33.SRE1:
IP address of remote host [255.255.255.255]? 131.108.10.6
Name of file to copy []? c7600rsp72043-adventerprisek9-mz.122-33.SRE1
writing c7600rsp72043-adventerprisek9-mz.122-33.SRE1
Check the configuration register using the show version command. Set the
9.
router to boot from Flash memory.
10. Use the show running-config privileged command to determine whether the
router configuration includes the boot system flash global configuration
command in the correct order with respect to the other boot system
commands.
Note: The boot system global configuration commands are saved in the order in
which they were entered. The most recent entry goes to the bottom of the list.
Configure the boot system flash command, if it is missing. Confirm that the
11.
order of boot system commands is correct. Use the copy running-config
startup-config command to save this change. The required syntax is as
follows:
copy running-config {rcp | startup-config | tftp | file-id}
Syntax description:
startup-config—Specifies the configuration used for initialization as the
destination of the copy operation.
tftp—Specifies a TFTP server as the destination of the copy operation.
file-id—Specifies device:filename as the destination of the copy operation. The
device argument is optional, but when it is used, the colon (:) is required.
Enter the reload privileged command to restart the router.
Chapter 4 Troubleshooting
OL-5077-7