Installing Modules; Required Tools - Cisco 7603 - Modular Expansion Base Installation Manual

Installing Modules

This chapter describes how to install and verify the operation of the supervisor engines, Optical Services
Modules (OSMs), recommended Catalyst 6000 family modules, and SPA interface processors (SIPs) in
the Cisco 7600 series router, and it contains these sections:
•
•
•
•
•
•
•

Required Tools

This section describes the requirements and the tools you need to install the supervisor engine or the
module.
Before installing modules, you must install the Cisco 7600 series router chassis and at least one
Note
supervisor engine. For information on installing the chassis, refer to the Cisco 7600 Series Router
Installation Guide or Cisco 7609 Router Installation Guide.
These tools are required to install modules in the Cisco 7600 series router:
•
•
•
OL-5077-7
Required Tools, page 3-1
Installing a Supervisor Engine or a Module, page 3-2
Removing the Supervisor Engine or a Module, page 3-13
Connecting the Supervisor Engine, page 3-15
Installing and Removing GBICs, page 3-17
Using Flash PC Cards, page 3-20
Verifying the Installation, page 3-22
Flat-blade screwdriver
Wrist strap or other grounding device
Antistatic mat or antistatic foam
3
C H A P T E R
Book Title
3-1