Catalyst 6000 Family Module Led Descriptions; Spa Interface Processors - Cisco 7603 - Modular Expansion Base Installation Manual

Chapter 1 Product Overview

Catalyst 6000 Family Module LED Descriptions

The front-panel LEDs for the Catalyst 6000 family modules are described in
Table 1-17 Catalyst 6000 Family Module LEDs
LED Color
STATUS
Red
Orange
Green
Green to
Orange
Off
LINK
Green
Orange
Flashing
orange
Off
1. CLI = command-line interface.
2. Thie is a good time to verify that all LINK LEDs are functioning.

SPA Interface Processors

This section describes the SPA interface processors (SIPs) for the Cisco 7600 series router. Summary
descriptions of the SIPs that are supported on the Cisco 7600 series routers are shown in
The description column indicates the aggregate bandwidth supported by the SIP across all subslots—not
Note
per SPA subslot.
OL-5077-7
Description
The module is resetting. (The system has just been powered on or the
module has been hot inserted—this is the normal initialization
sequence.)
An overtemperature condition has occurred. (A major threshold has
been exceeded during environmental monitoring.)
If the module fails to download code and configuration information
successfully during the initial reset, the LED stays red; the module does
not come online.
The module is booting or running diagnostics (the normal initialization
sequence).
An overtemperature condition has occurred. (A minor threshold has
been exceeded during environmental monitoring.)
All diagnostics pass; the module is operational.
The module is disabled through the CLI.
The module is not receiving power.
The port is active (link connected and operational).
The module or port is disabled through the CLI command or the module
is initializing.
The port is faulty and has been disabled.
The port is not active or the link is not connected.
1
2
SPA Interface Processors
Table 1-17.
Table 1-18.
Book Title
1-29