Repair; General Information; Repair And Conversion Concept; Endress+Hauser Services - Endress+Hauser Dosimass IO-Link Operating Instructions Manual

Dosimass IO-Link
Endress+Hauser
14

Repair

14.1

General information

14.1.1

Repair and conversion concept

The Endress+Hauser repair and conversion concept provides for the following:
• The measuring device cannot be converted.
• If the measuring device is defective, the entire device is replaced.
• It is possible to replace seals.
14.2

Endress+Hauser services

Endress+Hauser offers a wide range of services.
Your Endress+Hauser Sales Center can provide detailed information on the services.
14.3

Return

The requirements for safe device return can vary depending on the device type and
national legislation.
1. Refer to the web page for information:
https://www.endress.com/support/return-material
 Select the region.
2. If returning the device, pack the device in such a way that it is reliably protected
against impact and external influences. The original packaging offers the best
protection.
14.4

Disposal

If required by the Directive 2012/19/EU on waste electrical and electronic
equipment (WEEE), the product is marked with the depicted symbol in order to
minimize the disposal of WEEE as unsorted municipal waste. Do not dispose of
products bearing this marking as unsorted municipal waste. Instead, return them to
the manufacturer for disposal under the applicable conditions.
14.4.1

Removing the measuring device

1. Switch off the device.
WARNING
L
Danger to persons from process conditions!
‣
Beware of hazardous process conditions such as pressure in the measuring device, high
temperatures or aggressive media.
2. Carry out the mounting and connection steps from the "Mounting the measuring
device" and "Connecting the measuring device" sections in reverse order. Observe the
safety instructions.
Repair
47