Configure The User Event Notification - Magtek DynaFlex User Manual

8 - How to use Configurations
8.9

Configure the User Event Notification

The device only detects these user events and sends these notifications when it is idle. While processing a
command (not idle), such as when processing a transaction, the device only sends notifications related to
the command it is currently processing. Property change takes effect after the device is power cycled or
reset.
1) Select menu. Select the appropriate settings under ,
SYSTEM User Event Notifications Enable
and then press the button.
Set
2) Press the OK button to reset the device for the changes to take effect.
3) Confirm the changes by pressing the button after the device reset is complete.
Get
DynaFlex, DynaProx| Utility | User Manual (Windows)
Page 42 of 80 (D998200402-704)