Champion Model 44 Installation And Service Manual page 16

Installation
Attach the dishtables
1. Attach dishtables (supplied by others) to the load and unload ends of the dishwasher.
2. The table must fit over the dishwasher end flange and extend down into the
dishwasher.
3. The dishtables must angle toward the dishwasher so water on the tables will drain
into the dishwasher. The dishtables should have adjustable feet to adjust the angles.
4. Use a food grade silicon sealant to seal the joints between the dishtables and the
dishwasher.
Install a table-limit switch
A table-limit switch prevents damage to the dishwasher conveyor drive if dishracks pile up
on the unload dishtable and jam the conveyor.
A TABLE-LIMIT SWITCH INSTALLATION KIT, P/N 407400 with installation instructions
is available from Champion.
Damage to the dishwasher conveyor drive can happen
when dishracks jam together on the unload dishtable.
Final Installation Checks
1. Remove any foreign material from inside of the machine.
2. Check dishwasher drain/overflows are closed
3. Install scrap screens and baskets
4. Turn utilities on.
5. Turn dishwasher on to fill tanks with water.
6. Check tank water temperatures reach proper levels.
7. Check for leaks.
8. Drain the dishwasher and check that floor drains handle the
water volume leaving the dishwasher.
8
!!ATTENTION!!
Champion strongly recommends
the installation of a table-limit switch to prevent
dishrack jams at the unload of the dishwasher.