InstallatOn; Unpack And Place - Champion Model 44 Installation And Service Manual

Unpack and Place

Use caution when moving or lifting the dishwasher to prevent
damaging the dishwasher or the installation site.
Check doorway and passageway clearance before moving
the dishwasher.
Remove dishwasher front panels and check under the
machine base for obstructions before moving.
1. Inspect the dishwasher for shipping damage and immediately report any damage to the
freight carrier. Save all packing materials.
2. Check the dishwasher interior for curtains, panels and other supplies.
3. Lift the dishwasher off the shipping pallet and move the machine to its permanent location.
4. Leave a minimum of 6" between walls and the rear of the dishwasher.
5. Level the dishwasher side-to-side and front-to-back using a bubble level.
The dishwasher legs are adjusted by screwing them in or out.
6. Do not remove tags attached to the utility connections.
7. Remove the protective film from the dishwasher exterior.
Remove any foreign material from the dishwasher interior.
Plumbing - Hot water supply
NOTE:
Only qualified personnel should make dishwasher plumbing connections.
Connections must meet local plumbing and sanitary codes.
Improper installation is not covered by the dishwasher limited warranty.
1. Connect a 3/4" NPT hot water supply line to the line strainer located at the top rear of the
dishwasher.
For a dishwasher without a booster heater, the hot water connection must supply a
minimum of 180ºF/80ºC (measured at the dishwasher).
For a 40ºF/22ºC rise booster heater, the hot water connection must supply a minimum of
140ºF/60ºC (measured at the dishwasher).
For a 70ºF/39ºC rise booster heater, the hot water connection must supply a minimum of
110ºF/45ºC (measured at the dishwasher).
For a low temperature chemical sanitizing machine, the hot water connection must supply
a minimum of 140ºF/60ºC (measured at the dishwasher).
2. Install a pressure reducing valve (PRV) before the dishwasher supply connection if the
flowing line pressure is greater than 25psi [173kPa] at the machine. Set the PRV flowing
pressure to 20-22psi [138-151 kPa]. PRV's are supplied by Champion or others.
!!ATTENTION!!
Installation
Installation
3