Receiving Problems - Canon FaxPhone L170 Basic Manual

Cannot send using ECM (Error Correction Mode).
Q
A
Errors occur frequently while sending.
Q
A

Receiving Problems

Cannot receive a fax automatically.
Q
A
Q
A
Q
A
13
Q
A
13-14 Faxing Problems
Does the receiving fax machine support ECM?
If the receiving fax machine does not support ECM, the document is sent in the normal mode without error checking.
Are the telephone lines in proper condition? Do you have a good connection?
Lower the transmission speed. (See "3.TX START SPEED," on p. 15-6.)
Is the machine set to receive automatically?
For the machine to receive faxes automatically, the receive mode must be set to <FaxOnly> mode or <AnsMode>. (See
Chapter 7, "Receiving Faxes.") If you have set <AnsMode>, confirm that an answering machine is connected to the machine
and that it is turned on with an outgoing message properly recorded.
If you set <5. MAN/AUTO SWITCH> to <ON> in <FAX SETTINGS> of the Menu, the machine will receive faxes
automatically even when the receive mode is set to <Manual> mode. (See "5.MAN/AUTO SWITCH," on p. 15-10.)
Is the memory full?
Wait for the machine to finish any fax or print jobs stored in the memory or delete them from the memory. (See "Deleting a
Fax job," p. 11-2.) Then ask the other party to resend the fax.
Did an error occur during reception?
Print an ACTIVITY REPORT and check for an error. (See "Activity Report," on p. 12-1.) You can also check the RX REPORT
when it is printed automatically. (See "Reception (RX) Report," on p. 12-4.)
Is the telephone line connected properly?
Make sure all line connections are secure. (See "Connecting the Telephone Line," on p. 2-7.)