Canon FaxPhone L170 Basic Manual page 142

Message
REC. PAPER JAM
RECEIVED IN MEMORY
REMOVE MP PAPER
REPLACE CARTRIDGE
SCANNING
MAKING SPACE IN MEM
PLEASE WAIT
START AGAIN
SUPPLY REC. PAPER
SYSTEM ERROR
Exxx*
TX/RX NO. nnnn**
13
* xxx stands for a number.
** The identification number does not appear in the standby mode. It appears when scanning documents, operating [System Monitor],
receiving faxes in Manual mode or memory, or after transmission is completed.
13-8 LCD Messages
Cause
There is a paper jam.
The machine received the fax in memory
because paper or toner ran out, a paper
jam occurred, or incorrect paper size was
loaded.
Paper is loaded in the multi-purpose
feeder.
The toner cartridge ran out of toner or is
not installed properly.
Memory is getting low during scanning
because the document has many
graphics or photos.
The paper in the cassette has run out, the
toner has run out, paper jams have
occurred, or the paper size setting is
wrong while the report is printing.
No paper is loaded in the cassette or
multi-purpose feeder.
An error of some kind has occurred
in the machine.
When the machine sends or receives a
fax, it assigns a unique identification
number (nnnn).
Action
Clear the paper jam (See pages 13-1 to 13-6.) and reload paper
in the cassette or multi-purpose feeder. Then reset the machine
by opening the printer cover and then closing it.
Load correct paper size in the cassette, replace the cartridge, or
clear the paper jam. (See p.7-6.)
Remove the paper from the multi-purpose feeder. If the machine
receives the fax then paper is loaded in the multi-purpose feeder,
the received document will be stored in memory.
Make sure the toner in the cartridge is evenly distributed or the
cartridge is installed properly.
After doing this, if the message remains displayed or the print
quality is low, replace the cartridge. (See pages 2-16 to 2-18)
When memory space becomes available as printing continues,
the scanning resumes automatically.
Then reset the machine by opening the printer cover and then
closing it.
After loading paper in the cassette, replacing the cartridge,
clearing jams, or specifying the correct paper size, print the report
again.
Load paper in the cassette or multi-purpose feeder. (See pages
4-3 to 4-10.) Make sure the paper stack in the cassette does not
exceed the capacity of the cassette.
Load paper in the multi-purpose feeder one by one. (See pages
4-8 to 4-10.)
If you load paper while making copies, do not load a different
paper size.
Unplug the machine from the power supply and wait for approx. 3
minutes to 5 minutes, then plug it in again. If this does not solve
the problem, unplug the machine and call your service
representative.
Write down the number for future reference.