Auto-Threading Device - Brother PC-8200 User Manual

Auto-threading device

1
2
1 1
2
3
5
Needle Thread (cotton)
65/9
75/11
90/14
100/16
20
1. Guide the thread through the wire loop and gently pull the
thread towards you.
5
1 Needle threader lever
2 Guide (Large hook)
3 Wire loop
3
* Lowering the presser foot will engage the automatic tension
and will allow you to grip the thread as you proceed.
2. Lower the needle threader lever all the way down using your
left index finger. Check that the thread is held by the guide
(large hook) and that the hook on the needle threader has
5
passed through the eye of the needle.
1 Second set of hooks
2 Third hook
3. As you lower the needle threader lever drape the thread to
the left and the large hook will catch the thread. When the
needle threader lever is in the lowest position, drape the
thread across the eye of the needle.
* Rotating your right hand slightly to check that the thread is
engaged.
4. While gently holding the thread, raise the needle threader
lever.
5. Pull the thread towards the rear to finish the upper
threading.
5
6. Pass the thread underneath the presser foot and pull it out
from the rear of the machine by about 5 cm (1-15/16").
Note
The auto-threading device cannot be used with the
#30, 50, 60
combinations shown at left.
Transparent nylon thread can be used regardless of the chart
#30
providing needle used in 90/14 to 100/16.
#30
#20